Heat shrinkable bands are very convenient and useful materials for sealing joints. The following describes the installation steps for heat shrinkable bands. We hope users can better utilize this product.

Main steps: Use a spray gun to slowly heat the front end of the heated heat shrink band until it can be thoroughly adhered to the outer surface of the pipe. Press it with hands and rollers, then roll the heat shrink band or heat shrink sleeve along the hot rolled band or heat shrink sleeve. Therefore, the overlap between the two ends of the pipe and the anti-corrosion coating is no less than 100mm, and the circumferential overlap width is no less than 80mm.

Correctly heat the adhesive layer surface of the fastener and stick it to the joint. Heat the adhesive surface of the fastener with a spray gun. After the hot melt adhesive is completely melted, it can be quickly bonded to ensure firmness. The central part of the self-shrink sleeve is heated and shrunk along the circumference by a spray gun, and the flame of the spray gun is adjusted to ensure uniform temperature, so that the shrink band is uniformly shrunk into a trumpet shape, and the hot melt adhesive overflows from the periphery.

After shrinking, use the same method and then evenly heat one end of the pipe to prevent bubbles and wrinkles. Following the methods we have introduced, installing heat shrink bands will allow you to easily complete the operation.